MaxStream XStream-Pkg Manuál stáhnout pdf (Strana 14)

XStream‐PKG‐T™TelephoneRFModem–ProductManualv5.x00[2006.02.24]

©2006MaxStream,Inc.,ConfidentialandProprietary 14



2.1.5. Command Mode

To modify or read RF module parameters, the module must first enter into Command Mode - the

state in which incoming characters are interpreted as commands. Two command types are

available for programming the on-board RF module:

• AT Commands

• Binary Commands

Refer to the RF Module Configuration sections [beginning on the next page] for more information.

For information about programming the on-board telephone module, refer to the Telephone

Module Configuration [p

20] section.

NOTE: The XStream-PKG-T RF Modem automatically powers up to a Command Mode for the on-

board telephone module, the on-board RF Module does not. To enter RF Module into Command

Mode for the purpose of programming the module, follow the refer to the RF Module Configuration

section [next page].

www.agelectronica.com www.agelectronica.com

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 61 62

Žádné komentáře

MaxStream XStream-Pkg Manuál Strana 14