MaxStream XStream-PKG-R RS-485 Uživatelský manuál stáhnout pdf (Strana 2)

1. Launch the X-CTU Software:

(

Start --> Programs --> MaxStream --> X-CTU

)

Under the "PC Settings" tab [Figure 2], select the PC serial com port

from the dropdown list that will be used to connect to Radio1.

Select the Baud rate that matches the fixed RF data rate (over-the-air

baud) of Radio1. Use default values for remaining fields. [Figure 2]

4. Click on the "Range Test" tab. [Figure 3]

(Optional) Check the box in the "RSSI" section to enable its display.

Click the "Start" button to begin range test.

7. Move Radio2 (with loopback connector) away from Radio1 to measure the

modem's range.

Figure 3. Range Test tab

Figure 2. PC Se�ings tab

Use the "PC Settings" and "Range Test" tabs of the X-CTU software to:

• Assign which PC Serial Com Port to use when communicating with

XStream RF Modems [step 2 of "Range Test" below]

• Measure XStream RF Modem's range

[

steps 1-7 shown below]

Range Test

Range Test steps-to-follow

PC Serial Com Port

Default Values

Refer to XStream RF Modem part number

to determine its ﬁxed RF data rate (baud):

X09-009... = 9600 bps

X09-019... = 19200

X24-009... = 9600

X24-019... = 19200

Remaining Default Values:

Flow Control = None

Data Bits = 8

Parity = None

Stop Bits = 1

RSSI check box

RSSI stands for "Received Signal Strength Indicator".

Start/(Stop) button

(Packet Information)

1 2 3 4

Žádné komentáře

MaxStream XStream-PKG-R RS-485 Uživatelský manuál Strana 2